Installation Procedure
- Install the inflatable restraint I/P module (1).
- Install the I/P module retaining nuts (3).
Tighten: Tighten fasteners to 45 N.m (33 lb ft).
- Install the I/P module retaining bolts (4).
Tighten: Tighten fasteners to 9.5 N.m (84 lb in).
- Connect the I/P module connector (2).
- Install the I/P trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper in Instrument Panel, Gages and Console.
- Enable the SIR system. Refer to SIR Disabling and Enabling Zone 5 .
NOTE:
Refer to Fastener Notice in Cautions and Notices.