LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Rally, FWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.4L - Introduction - Service & Replacement >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of CMP Sensor
    GM16120Courtesy of GENERAL MOTORS CORP.
  1. Turn OFF the ignition.
  2. Remove the power steering pump. Refer toPower Steering Pump Replacement (LA1 )Power Steering Pump Replacement (LY7) in Power Steering System.
  3. Disconnect the sensor electrical connector.
  4. Remove the attaching bolt.
  5. Remove the sensor.
  6. Inspect the sensor O-ring for wear, cracks, or leakage if the sensor is not being replaced.
scientia non olet · About LEMON Manuals