LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Rally, AWD >> Repair and Diagnosis (Single Page) >> Suspension >> Electronic Suspension >> Suspension Control System - Suspension Leveling >> Repair Instructions >> Automatic Level Control Sensor Replacement >> Installation Procedure

Installation Procedure

  1. Install the automatic level control height sensor link onto the height sensor arm.
  2. Install the automatic level control height sensor with the bracket onto the vehicle.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    3. Fig 1: Identifying Automatic Level Control Height Sensor Bracket Bolts
    GM881333Courtesy of GENERAL MOTORS CORP.
  3. Install the automatic level control height sensor bracket bolts (1).

    Tighten:  Tighten the height sensor bracket bolts to 85 N.m (63 lb ft).

  4. Install the automatic level control sensor link to the lower control arm ball stud.
    5. Fig 2: View Of Automatic Level Control Sensor Electrical Connector
    GM881329Courtesy of GENERAL MOTORS CORP.
  5. Install the automatic level control sensor electrical connector (1).
  6. Lower the vehicle.
  7. Perform a diagnostic system check. Refer to Diagnostic System Check - Automatic Level Control (With Inflator) .
scientia non olet · About LEMON Manuals