LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Seat System) >> Repair Instructions >> Lumbar Support Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat assembly from the vehicle. Refer to Seat Replacement - Front Bucket .
  2. Remove the seat trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
  3. Remove the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Front .
  4. Pull the cover half-way up the seat back.
    5. Fig 1: Locating Lumbar Cable Clip On Lower Seat Back
    GM755850Courtesy of GENERAL MOTORS CORP.
  5. Remove the lumbar cable (2) from the cable clip (1) located on the lower seat back.
    6. Fig 2: Accessing Lumbar Mechanism
    GM755852Courtesy of GENERAL MOTORS CORP.
  6. Pull the seat back panel and pad away from the frame to expose the lumbar mechanism.
  7. Remove the cable from the lumbar spring.
    8. Fig 3: Identifying Lumbar Cable Routing
    GM755853Courtesy of GENERAL MOTORS CORP.
  8. Unhook the cable end from the lumbar mechanism.
    9. Fig 4: Locating Cable To Seat Adjuster Screws
    GM755848Courtesy of GENERAL MOTORS CORP.
  9. Remove 2 screws (1) securing the cable to the seat adjuster.
scientia non olet · About LEMON Manuals