LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 335 (Entertainment System) >> Repair Instructions >> Speaker Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the front door speaker assembly into position in the door.
    Fig 1: Front Door Speaker Assembly And Screws
    GM65112Courtesy of GENERAL MOTORS CORP.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: The tightening sequence MUST be followed.
  2. Install the front door speaker assembly retaining screws in the following sequence:
    1. The uppermost screw
    2. The lowermost screw
    3. The remaining screws in a criss -cross pattern

      Tighten:  Tighten the front door speaker assembly retaining screws in sequence to 2.5 N.m (22 lb in).

    3. Fig 2: Electrical/Audio Connector At Front Door Radio Speaker
    GM65114Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical/audio connector to the front door speaker assembly.
  4. Install the door trim panel. Refer to Trim Panel Replacement - Door in Doors.
scientia non olet · About LEMON Manuals