LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 335 (Entertainment System) >> Repair Instructions >> Radio Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front floor kick -up panel. Refer to Kick -Up Panel Replacement - Front Floor in Interior Trim.
  2. Remove the cover from the I/P electrical center.
    Fig 1: Radio Control & Center Bracket
    GM65091Courtesy of GENERAL MOTORS CORP.
  3. Remove the RDO/CD MiniFuse® #5 from the I/P electrical center.
  4. Remove the console. Refer to Console Replacement in Instrument Panel, Gauges and Console.
  5. Remove the I/P accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory in Instrument Panel, Gauges and Console.
  6. Remove the screws retaining the radio control to the I/P center support bracket.
  7. Begin to remove the radio control from the center support bracket enough to access the connectors at rear of the radio control.
    8. Fig 2: Electrical/Audio And Coaxial Cable Connectors At Radio Control
    GM65093Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the electrical/audio and coaxial cable connectors from the radio control.
    9. Fig 3: Radio Control To Bracket Alignment
    GM65092Courtesy of GENERAL MOTORS CORP.
  9. Remove the radio control.
scientia non olet · About LEMON Manuals