Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Position the fascia extension to the fascia.

Fig 1: Fascia Extension

Courtesy of GENERAL MOTORS CORP.

Install the spring clips starting at the center of the fascia extension and working outward.

Fig 2: Fascia Extension Spring Clips

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws to the front fender liner at the front of the front bumper fascia.
Tighten: Tighten the front fender liner to fascia screws to 2 N.m (18 lb in).

Fig 3: Front Fender Liner To Front Bumper Fascia Screws

Courtesy of GENERAL MOTORS CORP.

Using new plastic rivits, install the 2 plastic rivits to the front bumper fascia extension corner and front fender liner.

Fig 4: Front Bumper Fascia Extension Plastic Rivits

Courtesy of GENERAL MOTORS CORP.

Install the lower fascia support. Refer toFascia Support Replacement - Front Bumper Lower (Impala) or Fascia Support Replacement - Front Bumper Lower (Monte Carlo) in Bumpers.
Lower the vehicle.