Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Generator & Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the generator.
Install the generator bolts.
Tighten: Tighten the bolts to 50 N.m (37 lb ft).

Fig 2: View Of Generator Cable Boot, Head, Nut & Bolt

Courtesy of GENERAL MOTORS CORP.

Install the generator cable (3) to the generator, perform the following:
1. Install the generator cable (3).
2. Install the generator cable nut (2) to the terminal stud.
  Tighten: Tighten the nut to 9 N.m (80 lb in).
3. Slide the boot (1) over the terminal stud.

Fig 3: View Of Generator Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the generator electrical connector.
Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory in Engine Mechanical - 4.8L, 5.3L, and 6.0L.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .