LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 107 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Replacement (4.2L Engine) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the generator and secure the generator with 3 bolts.

    Tighten:  Tighten the generator bolts to 50 N.m (37 lb ft).

    2. Fig 1: Rear Of Generator (Alternator) View
    GM754357Courtesy of GENERAL MOTORS CORP.
  2. Connect the battery positive cable to the generator and secure the positive cable with the nut (1).

    Tighten:  Tighten the generator positive cable nut to 9 N.m (80 lb in).

    3. Fig 2: View Of Engine Lift Bracket
    GM750247Courtesy of GENERAL MOTORS CORP.
  3. Install the engine lift hook and secure the lift hook with 2 bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    4. Fig 3: View Of Engine Lift Hook & A/C Bracket Bolt
    GM754344Courtesy of GENERAL MOTORS CORP.
  4. Install the A/C line bracket to the lift hook and secure the bracket with the bolt.

    Tighten:  Tighten the A/C line bracket bolt to 10 N.m (89 lb in).

  5. Install the drive belt. Refer to Drive Belt Replacement in Engine Mechanical - 4.2L.
  6. Connect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
scientia non olet · About LEMON Manuals