LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, FWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body Rear End >> Repair Instructions >> Support Cable Replacement - Endgate >> Installation Procedure

Installation Procedure

  1. Position the endgate support cable to the endgate.
    Fig 1: View Of Endgate Support Cable
    GM621898Courtesy of GENERAL MOTORS CORP.
  2. Install the bolts to the endgate support cable.

    Tighten:  Tighten the endgate support cable bolts to 3 N.m (27 lb in).

  3. Remove the support from the endgate.
  4. Close the endgate.
scientia non olet · About LEMON Manuals