LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, FWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body Rear End >> Repair Instructions >> Handle Replacement - Endgate >> Installation Procedure

Installation Procedure

  1. Install the endgate handle to the endgate handle assembly.
    Fig 1: Identifying Endgate Handle Assembly
    GM625149Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts to the endgate handle.

    Tighten:  Tighten the endgate handle bolts to 10 N.m (89 lb in).

  3. Close the endgate.
scientia non olet · About LEMON Manuals