LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, FWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body Front End >> Repair Instructions >> Hood Latch Release Handle Replacement >> Installation Procedure

Installation Procedure

  1. Install the hood release cable to the hood release handle.
    Fig 1: Locating Hood Release Handle
    GM630479Courtesy of GENERAL MOTORS CORP.
  2. Install the hood release handle to the instrument panel.
    Fig 2: Hood Release Handle Base
    GM182644Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolts to hood release handle base.

    Tighten:  Tighten the hood release handle base bolts to 2 N.m (18 lb in).

  4. Install the knee bolster panel. Refer to Knee Bolster Replacement in Instrument Panel, Gauges, and Console.
  5. Install the left IP Insulator Panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gauges, and Console.
scientia non olet · About LEMON Manuals