LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension System >> Repair Instructions >> Wheel Stud Replacement >> Installation Procedure

Installation Procedure

  1. Install a new wheel stud from the back side of the wheel bearing/hub.
    2. Fig 1: Installing Wheel Stud
    GM65317Courtesy of GENERAL MOTORS CORP.
  2. Install three flat washers (1) to the wheel stud (3).
  3. Install a hex nut (2) to the wheel stud (3).
    4. Fig 2: Seating Stud Head In Wheel Bearing/Hub Flange
    GM175950Courtesy of GENERAL MOTORS CORP.
  4. Tighten the hex nut until the stud head is fully seated in the wheel bearing/hub flange.
  5. Remove the hex nut and the washers from the wheel stud.
  6. For front wheel drive vehicles, install the brake drum. Refer to Brake Drum Replacement in Drum Brakes.

    For all wheel drive vehicles, install the rear brake rotor. Refer to Brake Rotor Replacement - Rear in Disc Drakes.

  7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals