LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Column Anchor Cable Replacement >> Installation Procedure

Installation Procedure

  1. Properly route the steering column anchor cable.
    2. Fig 1: View Of Anchor Cable Nut On Center Console Bracket
    GM545578Courtesy of GENERAL MOTORS CORP.
  2. Install the anchor cable to the center console bracket stud.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the anchor cable nut to the center console bracket stud.

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

  4. Install the steering column anchor cable end to the steering column stud.
    5. Fig 2: Identifying Steering Column Upper Nut
    GM545583Courtesy of GENERAL MOTORS CORP.
  5. Install the steering column nut. Refer to Steering Column Replacement .
  6. Install the center console. Refer to Console Replacement - Front Floor (Aztek) or Console Replacement - Front Floor (Rendezvous) in Instrument Panel, Gages and Console.
  7. Install the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals