Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Lamp To Bracket & Screws

Courtesy of GENERAL MOTORS CORP.

Install the front park/turn signal and sidemarker lamp into position on the front turn signal lamp bracket.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the front park/turn signal and sidemarker lamp to bracket retaining screws.
Tighten: Tighten the front park/turn signal and sidemarker lamp to bracket retaining screws to 2 N.m (18 lb in).

Fig 2: Sockets To Lamp

Courtesy of GENERAL MOTORS CORP.

Install the sockets to the lamp.

Fig 3: Lamp Bracket To Front Fascia

Courtesy of GENERAL MOTORS CORP.

Install the lamp, with the bracket, to the front fascia.
Align the lamp to the opening in the front fascia and hold the lamp firmly in place against the fascia, while installing the front turn signal lamp bracket retaining screws.
Tighten: Tighten the front turn signal lamp bracket retaining screws to 3 N.m (27 lb in).
Install the lamp bracket retaining spring to the front fascia.
Install the front turn signal lamp bracket retaining spring to the lamp bracket.

Fig 4: Brake Caliper Cooling Duct To Front Fascia

Courtesy of GENERAL MOTORS CORP.

Position the brake caliper cooling duct to the front fascia and press the duct toward the fascia to secure.
Install the front fascia lower closeout panel. Refer to Close Out Panel - Front Bumper Fascia Lower in Bumpers.