LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 331 (Lighting Systems) >> Repair Instructions >> Headlamp Bezel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: RH Headlamp Wiring Harness Electrical Connector To Forward Lamp Wiring Harness
    GM64644Courtesy of GENERAL MOTORS CORP.
  1. Open the hood.
  2. Disconnect the headlamp wiring harness electrical connector from the forward lamp wiring harness.
  3. Remove the rear screw attaching the headlamp bezel.
    4. Fig 2: Headlamp Actuator Knob Cover
    GM777768Courtesy of GENERAL MOTORS CORP.
  4. Remove the headlamp motor/actuator knob cover.
  5. Rotate the headlamp motor/actuator manual control knob counterclockwise to raise the headlamp.
    6. Fig 3: Headlamp Bezel To Headlamp Opening Door
    GM64647Courtesy of GENERAL MOTORS CORP.
  6. Remove the screws from the side of the headlamp bezel.
    7. IMPORTANT: The headlamp bezel has a tab (3) which fits into a retaining clip (2) on the underside of the headlamp opening door (1). Observe caution when separating the parts.
  7. Pull the rear sides of the bezel out slightly, then begin to raise the rear sides and pull the bezel away from the headlamp opening door.

    Pull the bezel to release the bezel tab (3) from the retaining clip (2) on the underside of the headlamp opening door (1).

  8. Remove the headlamp bezel from the vehicle.
scientia non olet · About LEMON Manuals