Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Fog Lamp Bezel At Lamp Assembly

Courtesy of GENERAL MOTORS CORP.

Position the rear fog lamp assembly to the rear fascia.
Install the bezel to the lamp.
Insert the bezel into the slot on the lamp, then pivot the bezel onto the stud.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the rear fog lamp bezel retaining nut.
Tighten: Tighten the rear fog lamp bezel retaining nut to 2 N.m (18 lb in).

Fig 2: Rear Fog Lamp Socket At Rear Fog Lamp Assembly

Courtesy of GENERAL MOTORS CORP.

Install the socket to the lamp.
Install the tail/turn signal lamp. Refer to Tail/Turn Signal Lamp Replacement (Europe, Japan) .