LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 297 (Front Suspension System) >> Repair Instructions >> Steering Knuckle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the knuckle to the vehicle.
    2. Fig 1: View Of Steering Knuckle To Strut Bolts
    GM385564Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the through bolts and nuts attaching the strut to the knuckle.

    Tighten:  Tighten the through bolts and nuts to 120 N.m (89 lb ft).

  3. Connect the outer tie rod to the steering knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement in Power Steering System.
  4. Connect the front lower control arm ball stud to the knuckle. Refer to Lower Control Arm Replacement .
  5. Install the front wheel drive shaft bearing. Refer to Wheel Bearing/Hub Replacement - Front .
  6. Lower the vehicle.
  7. Inspect the front wheel alignment and adjust if necessary. Refer to Measuring Wheel Alignment in Wheel Alignment.
scientia non olet · About LEMON Manuals