LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 297 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Stabilizer Shaft
    GM1208429Courtesy of GENERAL MOTORS CORP.
  1. Loosely install the stabilizer shaft to the vehicle.
  2. Connect the stabilizer shaft links to the stabilizer shaft. Do not tighten at this time.
    3. Fig 2: Insulator Clamp Bolts
    GM1208422Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the insulator clamps and bolts to the frame.

    Tighten:  Tighten the stabilizer shaft clamp bolts to 30 N.m (22 lb ft).

  4. Tighten the stabilizer link nuts.

    Tighten:  Tighten the stabilizer shaft link nut to 45 N.m (33 lb ft).

  5. Install the left tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals