LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Engine Controls (Introduction) - 3.8L) >> Repair Instructions >> Air Cleaner Intake Duct Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. If removed, install the clamps to the air cleaner intake duct.
    2. Fig 1: View Of Air Cleaner Intake Duct
    GM1208107Courtesy of GENERAL MOTORS CORP.
  2. Install the MAF/IAT sensor to the air cleaner intake duct.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the air cleaner intake duct to the throttle body and the air cleaner cover.

    Tighten:  Tighten the duct clamps to 3 N.m (27 lb in).

  4. Connect the PCV tube.
  5. Connect the MAF/IAT sensor electrical connector (2).
  6. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L26) or Fuel Injector Sight Shield Replacement (L32) in Engine Mechanical - 3.8L.
scientia non olet · About LEMON Manuals