LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 242 (Engine Exhaust System) >> Repair Instructions >> Exhaust Hanger Mounting Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the exhaust muffler rear hanger bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the inboard and the outboard rear bumper impact bar bolts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    3. Fig 1: Installing Exhaust Muffler Rear Hanger Bracket
    GM194726Courtesy of GENERAL MOTORS CORP.
  3. Install the exhaust pipe rear hanger insulators to the exhaust muffler rear hanger bracket.
    4. Fig 2: Installing Exhaust Pipe Rear Hanger Insulators
    GM289499Courtesy of GENERAL MOTORS CORP.
  4. Remove the support from the exhaust system.
  5. Inspect the exhaust system for underbody contact.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals