Removal Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the electrical connector from the brake fluid level sensor.
- Disconnect the brake pipes from the master cylinder.
- Plug the open brake pipe ends.
- Remove master cylinder mounting nuts.
- Remove the master cylinder from the vehicle.
- Drain the master cylinder reservoir of all brake fluid.
IMPORTANT:
Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.