LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 223 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Oil Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the oil pump (200) to the valve body (300).
    2. Fig 1: Oil Pump & Valve Body View
    GM48212Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the oil pump bolts (206,207).

    Tighten: 

    • Tighten the M6 X 1.0 X 85 bolts (207) to 12 N.m (106 lb in).
    • Tighten the M6 X 1.0 X 95 bolts (206) to 16 N.m (12 lb ft).

    3. Fig 2: Identifying Oil Pump Bolt Lengths And Positions
    GM164795Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connectors to the solenoid valves (315A, 315B, 322, 334 and 440), the TFP manual valve position switch (395) and the temperature sensor (391).
    4. Fig 3: Locating Wiring Harness & Electrical Connectors
    GM48209Courtesy of GENERAL MOTORS CORP.
  4. Install the case side cover. Refer to Case Side Cover Replacement .
scientia non olet · About LEMON Manuals