LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 223 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Oil Pan Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the oil pan gasket (25).
  2. Install the oil pan (24).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the oil pan bolts (23).

    Tighten:  Tighten the bolts to 14 N.m (10 lb ft).

    4. Fig 1: View Of Transaxle Oil Pan And Gasket
    GM164804Courtesy of GENERAL MOTORS CORP.
  4. Lower the vehicle.
    5. NOTE: Refer to Do Not Overfill the Transmission Notice in Cautions and Notices.
  5. Fill the transaxle with DEXTRON® III. Refer to Fluid Capacity Specifications .
  6. Place the gear selector in the Park position.
  7. Start the engine.
  8. Run the engine at a slow idle. Do NOT race the engine.
  9. Adjust the fluid level.
  10. Inspect for leaks.
scientia non olet · About LEMON Manuals