LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 223 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Automatic Transmission Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the transaxle mount to the frame.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the transaxle mount lower nuts to the frame.

    Tighten:  Tighten the transaxle mount lower nuts to 63 N.m (46 lb ft).

    3. Fig 1: Transaxle Mount
    GM462438Courtesy of GENERAL MOTORS CORP.
  3. Lower the transaxle so the transaxle mount studs install into the transaxle bracket.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the transaxle mount upper nuts to the transaxle mount.

    Tighten:  Tighten the transaxle mount upper nuts to 47 N.m (35 lb ft).

    5. Fig 2: Lower Transaxle Assembly
    GM630964Courtesy of GENERAL MOTORS CORP.
  5. Remove the transmission jack from the transaxle.
  6. Install left inner splash shield.
  7. Install the left wheel and tire assembly.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals