LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 222 (Front Suspension System) >> Repair Instructions >> Steering Knuckle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the knuckle to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts and nuts attaching the strut to the knuckle.

    Tighten:  Tighten the strut to knuckle bolts to 120 N.m (89 lb ft).

    3. Fig 1: View Of Steering Knuckle To Strut Bolts
    GM385564Courtesy of GENERAL MOTORS CORP.
  3. Install the outer tie rod to the steering knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement in Power Steering System.
  4. Connect the front lower control arm ball stud to the knuckle. Refer to Lower Control Arm Replacement .
  5. Install the front wheel drive shaft bearing. Refer to Wheel Bearing/Hub Replacement - Front .
  6. Lower the vehicle.
  7. Inspect the front wheel alignment and adjust if necessary. Refer to Measuring Wheel Alignment in Wheel Alignment.
scientia non olet · About LEMON Manuals