LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 215 (Wiper System & Washer System) >> Repair Instructions >> Washer Solvent Container Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the washer solvent container to the right frame rail.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the washer solvent container bracket screw.

    Tighten:  Tighten the screw to 10 N.m (89 lb in).

    3. Fig 1: Washer Solvent Container Bracket Screw
    GM815209Courtesy of GENERAL MOTORS CORP.
  3. Connect the washer solvent level sensor electrical connector.
    4. Fig 2: Identifying Washer Pump Hose, Washer Pump Electrical Connector, & Washer Solvent Level Sensor
    GM815208Courtesy of GENERAL MOTORS CORP.
  4. Connect the washer pump electrical connector.
  5. Connect the washer pump hose.
  6. Install the front fender liner. Refer to Front Fender Liner Replacement in Body Front End.
  7. Install the washer solvent container screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

    8. Fig 3: Installing Washer Solvent Container Screws
    GM815206Courtesy of GENERAL MOTORS CORP.
  8. Install the right headlamp assembly. Refer to Headlamp Assembly or Headlamp Bulb and/or Cornering, Sidemarker, Park, Turn Signal Bulb Replacement (Impala) or Headlamp Assembly or Headlamp Bulb and/or Cornering, Sidemarker, Park, Turn Signal Bulb Replacement (Monte Carlo) in Lighting Systems.
  9. Install the washer solvent container filler neck. Refer to Washer Solvent Container Filler Neck Replacement .
  10. Fill the washer solvent container with washer solvent.
scientia non olet · About LEMON Manuals