LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Body Front End) >> Repair Instructions >> Hood Latch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the hood release cable to the hood latch.
    Fig 1: Hood Release Cable
    GM456709Courtesy of GENERAL MOTORS CORP.
  2. Align the hood latch to the marks on the center support bracket.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 2: Hood Latch & Bolts
    GM363798Courtesy of GENERAL MOTORS CORP.
  3. Install the bolts that secure the hood latch to the center support.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  4. Install the support bracket to the front upper fascia. Refer to Fascia Support Bracket Replacement - Front Upper in Bumpers.
  5. Install the upper radiator air baffle. Refer to Radiator Air Baffle and Deflector Replacement - Upper in Engine Cooling.
  6. Adjust the hood, if required. Refer to Hood Adjustment .
  7. Close the hood.
scientia non olet · About LEMON Manuals