LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Body Front End) >> Repair Instructions >> Hood Hinge Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the hood hinge to the fender.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Hood Hinge To Fender Bolts
    GM363782Courtesy of GENERAL MOTORS CORP.
  2. Install the hood hinge to fender bolts.

    Tighten:  Tighten the hood hinge to fender bolts to 25 N.m (18 lb ft).

  3. Install the hood. Refer toHood Replacement .
  4. Install the hood assist rod. Refer to Assist Rod Replacement - Hood .
  5. Install the hood rear side seal. Refer to Seal Replacement - Hood Rear Side .
  6. Adjust the hood, as required. Refer to Hood Adjustment .
scientia non olet · About LEMON Manuals