Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Position the fender liner to the fender, over the stud and behind the rocker molding.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the nut to the stud at the rear of the front fender liner.
Tighten: Tighten the front fender liner stud nut to 4 N.m (35 lb in).

Fig 1: Installing Nut To Rear Of Front Fender Liner

GM456721

Courtesy of GENERAL MOTORS CORP.

Install the screws to the front fender liner at the front bumper fascia.
Tighten: Tighten the front fender liner to front bumper fascia screws to 2 N.m (18 lb in).

Fig 2: Installing Screws To Front Bumper Fascia

GM456724

Courtesy of GENERAL MOTORS CORP.

Install the screws to the front fender liner.
Tighten: Tighten the front fender liner screws to 2 N.m (18 lb in).

Fig 3: Installing Screws To Front Fender Liner

GM739317

Courtesy of GENERAL MOTORS CORP.

Using a new plastic rivet, install the plastic rivet to the rocker panel and front fender liner, if equipped.
Install the bolt to the front tab of the front fender liner at the lower engine compartment side rail.
Tighten: Tighten the front fender liner to rear of fender bolt to 7 N.m (61 lb in).

Fig 4: Installing Bolt To Front Tab

GM456723

Courtesy of GENERAL MOTORS CORP.

Using new plastic rivets, install the plastic rivets to the front fascia extension corner and front fender liner.

Fig 5: Front Fascia Extension Corner Plastic Rivets

GM738910

Courtesy of GENERAL MOTORS CORP.