LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Supplemental Inflatable Restraint System) >> Repair Instructions >> SIR Disabling and Enabling Zone 9 >> Enabling Procedure

Enabling Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from the ignition.

    Connect the inflatable restraint side impact module - LF connector (1), located under the driver seat.

    2. Fig 1: View Of Deployment Harness At Side Impact Module
    GM628320Courtesy of GENERAL MOTORS CORP.
  2. Install the CPA to the side impact module - LF connector.
  3. Connect the inflatable restraint I/P module connector, located at the RH side of the I/P.
    4. Fig 2: Connecting I/P Module Connector
    GM300141Courtesy of GENERAL MOTORS CORP.
  4. Install the CPA to the I/P module connector.
  5. Install the RH I/P access hole cover.
  6. Connect the steering wheel module coil connector.
    7. Fig 3: Connecting Steering Wheel Module Coil Connector
    GM217461Courtesy of GENERAL MOTORS CORP.
  7. Install the CPA from the inflatable restraint steering wheel module coil connector located at the base of the steering column.
  8. Install the LH insulator panel.
  9. Install the SIR Fuse.
    10. Fig 4: SIR Fuse
    GM300140Courtesy of GENERAL MOTORS CORP.
  10. Install the LH I/P access hole cover.
  11. Staying well away from all inflator modules and pretensioners, turn ON the ignition.
    1. The AIR BAG indicator will flash seven times.
    2. The AIR BAG indicator will then turn OFF.
  12. Perform Diagnostic System Check - SIR  if the AIR BAG indicator does not operate as described.
scientia non olet · About LEMON Manuals