Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Position the horn wire into the cam tower post. Rotate the horn wire clockwise until locked.

Fig 1: Driver SIR Module (Monte Carlo)

Courtesy of GENERAL MOTORS CORP.

Connect the yellow SIR coil lead wires to the module connectors. Connect pink to pink and gray to gray.
Install the CPA to each connector.

Fig 2: Installing CPA To Module (Monte Carlo)

Courtesy of GENERAL MOTORS CORP.

Route and secure the wires correctly:
- Secure the black redundant controls connector (1) to the feature at the 12 o'clock position on the steering wheel shroud. For the base steering wheel, the feature is at the 2 o'clock position.
- Route the yellow SIR coil lead wires (3) away from the 3 module mounting holes into the correct opening in the steering wheel insert.

Fig 3: Driver SIR Wiring (Monte Carlo)

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Do not force the module into place.

Install the 3 mounting posts on the module into the 3 holes (2,4,6) in the steering wheel:
- Set the left and right sides of the module evenly to the steering wheel.
- Gently press evenly on both sides and the bottom of the module until a clicking sound is heard.
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 .