LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 206 (Body Rear End) >> Repair Instructions >> Pressure Relief Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the pressure relief valve to the lower quarter panel.
  2. Press the pressure relief valve into the quarter lower panel until the retainers lock into place at the upper and lower locations.
    3. Fig 1: Pressure Relief Valve
    GM318859Courtesy of GENERAL MOTORS CORP.
  3. Pull back the rear compartment trim panel.
  4. Install the rear bumper fascia. Refer to Fascia Replacement - Rear Bumper (Impala) or Fascia Replacement - Rear Bumper (Monte Carlo) in Bumpers.
  5. Close the rear compartment.
scientia non olet · About LEMON Manuals