LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 200 (Engine Control System 3.8L (Introduction)) >> Repair Instructions >> Exhaust Gas Recirculation (EGR) Inlet Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the exhaust gas recirculation (EGR) valve inlet adapter pipe mounting bolt (2) from the exhaust manifold.
    3. Fig 1: Removing EGR Valve Inlet Adapter Pipe Mounting Bolt
    GM703604Courtesy of GENERAL MOTORS CORP.
  3. Lower the vehicle.
  4. Remove the EGR valve. Refer to Exhaust Gas Recirculation (EGR) Valve Replacement .
  5. Remove the EGR valve outlet pipe. Refer to Exhaust Gas Recirculation (EGR) Outlet Pipe Replacement .
  6. Remove the EGR valve inlet adapter pipe bolts (2,3).
  7. Remove the EGR valve inlet adapter pipe (1).
    8. Fig 2: Removing EGR Valve Inlet Adapter Pipe
    GM703601Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals