LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 (Wiring Systems - Introduction) >> Repair Instructions >> Instrument Panel Electrical Center or Junction Block Replacement - Left >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Remove the left I/P fuse block access hole cover.
  3. Disconnect the outboard wiring harness connector C2 from the junction block.
  4. Remove the connector position assurance (CPA) from the yellow inflatable restraint connector. Disconnect and reposition the yellow inflatable restraint connector for access to the bolts.
  5. Remove the steering column filler. Refer to Steering Column Filler Replacement in Instrument Panel, Gages, and Console.
  6. Remove the I/P driver knee bolster. Refer to Knee Bolster Bracket Replacement - Left in Instrument Panel, Gages, and Console.
  7. Disconnect the inner wiring harness connector from the junction block.
    8. Fig 1: Wiring Harness & Junction Block - Left
    GM615703Courtesy of GENERAL MOTORS CORP.
  8. Remove the junction block bolts.
  9. Remove the junction block tab from the slot in the cross vehicle beam. Pull the junction block away from the I/P.
  10. Remove the junction block.
    11. Fig 2: Removing Junction Block - Left
    GM615534Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals