Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Blower Motor Resistor

Courtesy of GENERAL MOTORS CORP.

Install the blower motor resistor (1).

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the blower motor resistor mounting screws (2).
Tighten: Tighten the screws to 1.9 N.m (17 lb in).
Connect the blower motor resistor electrical connector (3).
Install the right closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Right in Interior Trim.