Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Door Sealing Weatherstrip

Courtesy of GENERAL MOTORS CORP.

Install the side reveal molding (2) to the windshield pillar. Ensure the bottom edge is tucked under the outer edge of the air inlet panel grille.

Fig 2: Identifying Windshield Reveal Molding Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws to the side reveal molding.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 3: Removing/Installing Weather-Strip Retainers

Courtesy of GENERAL MOTORS CORP.

Install the push-pin retainers (2) to the front door sealing auxiliary weatherstrip located at the base of the pillar.
Close the door.