LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> Repair Instructions >> Wiper Motor Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Wiper Motor Module
    GM697659Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Position the wiper system drive module to the cowl.
  2. Install the wiper system drive module bolts.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

  3. Connect the wiper motor cover electrical connector.
  4. Install the cruise control module and bracket. Refer to Cruise Control Module Replacement in Cruise Control.
  5. Install the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement in Wiring Systems.
  6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  7. Install the wiper arms. Refer to Wiper Arm Replacement .
scientia non olet · About LEMON Manuals