LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2003 >> Vibe Base, AWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System - Removal & Installation >> Fuel Systems >> Fuel Tank Pressure Sensor >> Removal

Fuel Tank Pressure Sensor: Removal

  1. Remove the 2 rear seat cushion fasteners and swing the rear seat bottom cushion up and out of the way.
  2. Remove sill plate from the left side door opening.
  3. Fold back the carpet in order to maintain metal-to-metal contact while servicing the fuel sender assembly.
  4. Remove the access panel for the fuel sender assembly from the rear seat floor. The panel is held in place by a butyl caulk seal.
  5. Disconnect the fuel sender harness connector (1) from the fuel sender assembly. See Figure .
  6. Disconnect Fuel Tank Pressure (FTP) sensor (2) harness connector from the fuel sender assembly. See Figure .
  7. Remove FTP sensor retaining clip (2). See Fig 1 .
  8. Remove FTP sensor (1) from the fuel sender assembly.
Fig 1: Removing/Installing FTP Sensor Retaining Clip
G00180635Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals