Test Description
The numbers below refer to the step numbers on the diagnostic table.
- The exhaust system has very low back pressure under normal conditions. If the exhaust system is restricted, a significant increase in the exhaust pressure is noticed on the J 35314-A
.
- Removing the AIR check valve or HO2S sensor may set a DTC. When finishing this diagnostic table, be sure to clear all codes.
- If high back pressure is not found at idle, increasing the engine speed may help find a restriction.
- Perform operational check before returning vehicle to customer.
- This step will isolate the catalytic converter from the remainder of the exhaust system.
- Confirming that the condition has been fixed is essential. If the symptom still exists and the vehicle has a dual exhaust system, proceed to Step 2 and repeat diagnostic procedure on the opposite exhaust pipe.