Installation Procedure

NOTE: Refer to FASTENER NOTICE .

Install the wheel speed sensor (2) to steering knuckle.

Fig 1: Installing Speed Sensor And Retaining Bolt
Courtesy of GENERAL MOTORS CORP.

Tighten

Tighten the rear wheel speed sensor bolt (1) to 8 N.m (71 lb in).
Install the bolt (1) and nut (2) which retains the wheel speed sensor harness to the upper arm and suspension member.

Fig 2: Installing Speed Sensor Bolt And Nut
Courtesy of GENERAL MOTORS CORP.

Tighten

Tighten the bolt and nut to 5 N.m (44 lb in).
Install the bolt (2) which retains the wheel speed sensor harness (1) to the vehicle.

Fig 3: Installing Speed Sensor Harness And Bolt
Courtesy of GENERAL MOTORS CORP.

Tighten

Tighten the bolt and nut to 5 N.m (44 lb in).
Reposition the wheel speed pigtail harness through the body. Install the grommet.
Connect the wheel speed sensor electrical connector (1).

Fig 4: Installing Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Lower the vehicle.
Install the rear seat bottom and seat back. Refer to SEAT BACK REPLACEMENT - REAR SPLIT FOLDING in Seats.
Install the fuel tank filler pipe protector (1). Secure with 3 bolts (2).

Fig 5: Installing Fuel Tank Filler Pipe Protector
Courtesy of GENERAL MOTORS CORP.
Perform Diagnostic System Check - ABS .