Installation Procedure

Install the cable to the vehicle through the cowl and the carpet.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the cable grommet in the cowl.
Install the range select lever cable at the automatic transmission control.

Fig 1: View Of Range Select Lever Cable
Courtesy of GENERAL MOTORS CORP.
Install the front floor console. Refer to Console Replacement - Front Floor in Body - Instrument Panel and Console.
Install the range select lever cable to the cable bracket.

Fig 2: View Of Range Select Lever Cable
Courtesy of GENERAL MOTORS CORP.
Install the range select lever cable to the selector lever.

Fig 3: Identifying Automatic Transmission Cable & Selector Lever
Courtesy of GENERAL MOTORS CORP.
Connect the negative battery cable.
Adjust the cable.
1. Place the shift lever in N (Neutral). Rotate the selector shaft clockwise from P (Park) through R (Reverse) into N (Neutral).
2. With the shift control assembly in N (Neutral) lift the cable connector locking clip up.
3. Push the clip on the cable connector until fully seated and flush with cable body.