Shift Cable: Installation
- Install the shift cable through the hole in the dash. See Figure
.
- Install the shift cable through the console shift control bracket.
- Install the shift cable to the console shift control.
- Install the shift cable retainer to the console shift control.
- Install the shift cable to retaining clip(s) or retainer(s) in the passenger compartment.
- Install the carpet into position. Install the front floor console. See appropriate SHIFT INTERLOCK SYSTEMS article.
- Properly route and position the shift cable. See Fig 1
.
- Install the shift cable to the shift cable bracket. See Figure
.
- Install the shift cable to the Park/Neutral position switch. See Figure
.
- Place the transaxle in the Neutral position. Place the shift control in the Neutral position.
- Connect each cable section to the following before connecting the 2 cable sections.
- Insert the metal end fitting of the shift control cable into the transaxle cable end. See Figure
.
- Use the molded end fittings to push the metal end fitting of the shift control cable and the transaxle cable end together until the metal post snaps into place.
- Depress the adjuster clip once. This mobilizes the adjuster housing toward the transaxle end fitting.
- Line up the end fittings so they slide together until you feel the parts cam together and lock.
- Depress the adjuster clip completely. This locks the cable into its adjusted service position.
- Pull the conduit in the opposite direction to assure full system adjustment of the shift cable.
- The horseshoe clip with the tab is flush when fully engaged. Ensure the conduit is fully engaged
- The horseshoe clip with the tab is not flush when not fully engaged.
- Install the shift cable retainer and the wiring harness clip or the wiring harness strap.
- Adjust the shift cable. See SHIFT CABLE
under ADJUSTMENTS.
- Install the throttle body air inlet duct.
Courtesy of GENERAL MOTORS CORP.