Section 1 (Engine Controls Self-Diagnostics - 3.1L Engine): Programming: Notes

WARNING: This page is about a different variant/trim than selected.

NOTE: DO NOT program an existing PCM with the identical software/calibration package. This procedure is not a short cut to correct a driveability condition. This is an ineffective repair. A PCM should only be programmed when a service procedure instructs you to replace the PCM. The service part PCM does not contain operating software or calibrations or General Motors Corporation releases an updated software/calibration package.

After replacing Powertrain Control Module (PCM) or if program needs to be updated, refer to latest Techline® information on PCM reprogramming. PCM can only be programmed using Tech 2® and Techline® terminal, or by using a personal computer equipped with the current service programming system software installed.

Ensure that the following conditions are met before programming a control module: