LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2003 >> Aztek AWD >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension System >> Repair Instructions >> Wheel Stud Replacement >> Installation Procedure

Installation Procedure

  1. Install a new wheel stud from the back side of the wheel bearing/hub.
  2. Install three flat washers to the wheel stud.
  3. Install a hex nut to the wheel stud.
  4. Tighten the hex nut until the stud head is fully seated in the wheel bearing/hub flange.
  5. Remove the hex nut and the washers from the wheel stud.
  6. For front wheel drive vehicles, install the brake drum.
  7. Install the tire and wheel.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals