LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2003 >> Aztek AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 645 (Engine Controls (Introduction) -- 5.7L) >> Repair Instructions >> Knock Sensor (KS) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Knock Sensors
    GM54612Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the knock sensor.

    Tighten:  Tighten the knock sensor to 20 N.m (15 lb ft).

    2. Fig 2: Knock Sensor Wiring Harness Assembly
    GM54608Courtesy of GENERAL MOTORS CORP.
  2. Install the knock sensor wiring harness assembly.
  3. Install the intake manifold. Refer to Intake Manifold Replacement in Engine Mechanical.
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  5. Program the transmitters. Refer to Transmitter Programming in Keyless Entry.
scientia non olet · About LEMON Manuals