Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Parking/Sidemarker Lamp Bulb

Courtesy of GENERAL MOTORS CORP.

Install the bulb to the front parking/sidemarker lamp socket, if replacing the bulb.

Fig 2: View Of Front Parking/Sidemarker Lamp Socket

Courtesy of GENERAL MOTORS CORP.

Install the front parking/sidemarker lamp socket, turning the socket clockwise until the locking tab is fully seated.

Fig 3: Connecting Front Parking/Sidemarker Lamp Wiring Harness

Courtesy of GENERAL MOTORS CORP.

Connect the front parking/sidemarker lamp wiring harness to the pinch-weld flange.

Fig 4: Aligning Front Parking/Sidemarker Lamp Ball Stud To Grommet

Courtesy of GENERAL MOTORS CORP.

Align the ball stud of the front parking/sidemarker lamp to the grommet in the fender reinforcement.

Fig 5: View Of Front Parking/Sidemarker Lamp Alignment Pins

Courtesy of GENERAL MOTORS CORP.

Position the alignment pins of the front parking/sidemarker lamp to the to the holes in the fender reinforcement.

Fig 6: Locating Front Parking/Sidemarker Lamp

Courtesy of GENERAL MOTORS CORP.

Install the front parking/sidemarker lamp to the front fender, pressing into place until fully seated.

Fig 7: Locating Park/Turn Signal Lamp Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws to the front parking/sidemarker lamp.
Tighten: Tighten the front parking/sidemarker lamp screws to 2 N.m (18 lb in).
Close the hood.