LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2003 >> Aztek AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Charging System) >> Removal & Installation >> Generator >> Installation (3.8L)

Installation (3.8L)

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position generator to engine.
  2. Install positive battery lead to generator.
  3. Install generator output BAT terminal nut. Tighten generator output BAT terminal nut. See TORQUE SPECIFICATIONS  .
  4. Install protective boot to generator output BAT terminal.
  5. Connect electrical connector to generator.
    6. NOTE: Do not tighten stud.
  6. Install generator stud (2) to generator bracket. See Figure .
    7. NOTE: Do not tighten bolts
  7. Install generator bolts (1 & 3) to generator bracket.
  8. Tighten generator bolts and stud in order described. See TORQUE SPECIFICATIONS  . The following is a mandatory torque sequence:
    • Tighten generator bolt (1).
    • Tighten generator stud (2).
    • Tighten generator rear bracket bolt (3).
  9. Install generator rear brace.
  10. Install drive belt.
  11. Connect negative battery negative cable.
scientia non olet · About LEMON Manuals