Installation Procedure
- If the IP compartment lamp switch (2) was replaced perform the following steps:
- 1.1. Route the new IP compartment lamp switch wires through the opening in the IP carrier where the switch is mounted.
- 1.2. Connect the new IP compartment lamp switch wires to the existing splice.
- 1.3. Install the bulb to the IP compartment lamp switch.
- If the switch was not replaced pull the IP compartment lamp switch (2) back through the opening in the IP carrier.
- Connect the retainer (1) to the IP compartment lamp switch (2).
- Install the IP compartment lamp switch (2) through the opening in the IP carrier and press until the switch is fully seated.
Courtesy of GENERAL MOTORS CORP.
- Close the IP compartment door.
- Install the courtesy fuse to the IP electrical center.
- Verify the IP compartment lamp switch (2) for proper operation.