LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2002 >> Aztek FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1024 (Lighting Systems) >> Repair Instructions >> High Mounted Stop Lamp Replacement (Aztek) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying High Mounted Stop Lamp Plastic Retainer Nuts
    GM621199Courtesy of GENERAL MOTORS CORP.
  1. Install the high mounted stop lamp plastic retainer nuts to the roof panel pressing into place until fully seated.
    2. Fig 2: View Of High Mounted Stop Lamp
    GM621198Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connector to the high mounted stop lamp.
  3. Position the high mounted stop lamp retainer tabs to the slots in the roof panel.

    Press the high mounted stop lamp in place until fully seated.

    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 3: Identifying High Mounted Stop Lamp Screws
    GM621197Courtesy of GENERAL MOTORS CORP.
  4. Install the screws to the high mounted stop lamp.

    Tighten:  Tighten the high mounted stop lamp screws to 3.5 N.m (31 lb in).

scientia non olet · About LEMON Manuals